Hoppiness Bunnies Z Fold Card

March 23, 2021

Hoppiness Bunnies Z Fold Card

Hi and welcome, it’s Karen here today.  It’s starting to feel like an early spring here in my part of Canada and since it’s almost Easter, I couldn’t resist making a card with cute bunnies and Easter eggs. And of course, it needed to have a little surprise factor so I’ve made it a Z fold card. 





I started with a piece of cardstock that measured 4 1/4 x 11” long. I created a mask of hills which I first drew on some computer paper and then traced onto contact paper for masking. I made it so when the card is closed, it looks like one hill in the background. After masking off the sky, I ink blended the hills with Distress Oxide inks in Twisted Citron, Crushed Olive, Mowed Lawn and Rustic Wilderness.  Then I masked off the hills and used a stencil to create a cloudy sky with Cosmic Shimmer Clear Day Colour Cloud ink.  After the ink was dry, I creased this background at 2 3/4” and 5 1/2”.  The card folds over like a regular card at the 5 1/2” mark (a valley fold), but then folds back on itself at the 2 3/4” mark (a mountain fold) so the ink blended side is to the front. 

Next, I die cut grass from green cardstock (three layers for each half of the card).  On the left side, if you crease the grass layers at the 2 3/4” mark, it will help prevent the paper from tearing when the card is folded.  I diecut the tree using coloured cardstock, with a die from MFT Stamps.

I used Copic markers to colour all the images from the “Hoppiness” stamp set from Gerda Steiner Designs but couldn’t fit one of the bunnies on in the end. I also stamped and coloured two fence sections and two butterflies.

The eggs were made from some scrap pieces of Nuvo Shimmer Powder painted cardstock, and I added some Cosmic Shimmer Ultra Sparkle Paste in Gold and Frosty to a few of them before cutting them out.  I created my own egg shaped templates for the eggs. 

To assemble the card, I placed a small piece of masking tape where the left front of the card folded over to on the right side.  The hidden area of the card is to the left of this mark and over to the first fold on the left. Next, I stamped and heat embossed the sentiment with clear embossing powder on the right side so it would be visible when the card is closed.  To begin assembling, I first glued the tree on the left side.  Next, I glued the fence sections on either side of the card.  Then I started layering the grass rows, and added in eggs and bunnies until I was satisfied with the arrangement.  I kept all the eggs and bunnies in the hidden area, with the exception of the one bunny on the left front. I used glue to attach all the images as I didn’t want any excess bulk from foam tape.  The bunny on the left front is the only one I attached with foam tape.    

Finally, in order to have somewhere to write a message, I attached another A2 card base to the back of the card. Thanks so much for stopping by and I hope you have a happy, creative day! 





Leave a comment


Also in Gerda Steiner Designs

Oh My Gourd Birthday Card
Oh My Gourd Birthday Card

September 21, 2021 1 Comment

Hello, it’s Karen here again and thank you for stopping by. I’ve got a fun, 

Continue Reading

Pumpkin bear - Larissa
Pumpkin bear - Larissa

September 21, 2021 1 Comment

 Hi everyone, I am Larissa from Car-d-elicious and today it is my turn again to 

Continue Reading

Shine Bright
Shine Bright

September 21, 2021 1 Comment

Hi there,

    Continue Reading